Toshiba XDE600 - Manual (Page 14)

14
Connections C
Connecting to Optional Equipment
You can enjoy high quality dynamic sounds by connecting the DVD player to optional audio equipment.
Warnings
• When you are connecting (via the OPTICAL OUT or
COAXIAL DIGITAL AUDIO OUT jack) an AV decoder that
does not have Dolby Digital, DTS or MPEG2 decoding
function, be sure to set “Digital Output” to “PCM” from the
on-screen displays. Otherwise, high volume sound may
damage your hearing as well as the speakers.
• When playing DTS-encoded discs (DVDs and audio
CDs), excessive noise may be output from the analog
audio output jacks. To avoid possible damage to the
audio system, you should take proper precautions when
the analog audio output jacks of the DVD player are
connected to an amplifi cation system. To enjoy DTS Digital
Surround™ playback, an external 5.1 channel DTS Digital
Surround™ decoder system must be connected to the
OPTICAL OUT or COAXIAL DIGITAL AUDIO OUT jack
of the DVD player.
Note
• If Auto is selected, it follows preference HDMI aspect ratio of TV.
Content of the output for each output jack is shown in the following table and differ depending on the On-Screen Display
Setting:
Notes
• Do NOT connect the OPTICAL OUT or COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the AC-3 RF input of a Dolby
Digital Receiver. This input on your A/V Receiver is reserved for Laser disc use only and is incompatible with the OPTICAL
OUT /COAXIAL DIGITAL AUDIO OUT jack of the DVD player.
• Connect the COAXIAL DIGITAL AUDIO OUT jack of the DVD player to the “DIGITAL (COAXIAL)” input of a Receiver or
Processor.
• Connect the OPTICAL OUT jack of the DVD player to the “DIGITAL (OPTICAL)” input of a Receiver or Processor.
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening
level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifi er before you connect or disconnect the DVD player’s power cord. If you leave the amplifi er power on, the
speakers may be damaged.
• For connection to your TV, see “Connecting to a TV” .
• This section uses the following reference marks.
: Front speaker
: Rear speaker
: Sub woofer
: Center speaker
: Signal fl ow
On-Screen Display Setting Content of output for each output jack
“Video out”
Setting
HDMI Output
Setting
HDMI
Output
Video
Output
Component
Output
AV
Output
Component
(Interlaced)
Invalid - Composite 480i/576i -
RGB Invalid - Composite - RGB
P-Scan
(Progressive)
Invalid - Composite 480p/576p -
HDMI
480p/576p 480p/576p Composite 480i/576i -
720p 720p Composite 480i/576i -
1080i 1080i Composite 480i/576i -
1080p 1080p Composite 480i/576i -
1080p/24F 1080p/24F Composite 480i/576i -