Toshiba XDE600 - Manual (Page 12)

12
Connections C
Notes
• Refer to the owner’s manual of the connected equipment as well.
• When you connect the DVD player to other equipment, be sure to turn off the power and unplug all of the equipment from the
wall outlet before making any connections.
• If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the DVD
player away from the tuner and radio.
• The output sound of the DVD player has a wide dynamic range. Be sure to adjust the receiver’s volume to a moderate listening
level. Otherwise, high volume sound may damage your hearing as well as the speakers.
• Turn off the amplifi er before you connect or disconnect the DVD player’s power cord. If you leave the amplifi er power on, the
speakers may be damaged.
• When the TV system is set to NTSC mode, all output will be forced to NTSC type (eg. 525p(480p), 525i(480i), etc.)
• When the TV system is set to PAL mode, all output will be forced to PAL type (eg. 625p(576p), 625i(576i), etc.)
• Analogue audio out will not have sound if DTS playback is selected.
Interlaced outputs
Some TVs or monitors are equipped with component video inputs.
Connecting to these inputs allows you to enjoy higher quality picture
playback.
Actual labels for component video inputs may vary depending on the
TV manufacturer. (ex. Y, R-Y, B-Y or Y, C
B , C R )
In some TVs or monitors, the colour levels of the playback picture
may be reduced slightly or the tint may change. In such a case, adjust
the TV or monitor for optimum performance.
Progressive outputs
Some TVs or monitors are equipped with component video inputs
that are capable of reproducing a progressively scanned video signal.
Connecting to these inputs allows you to view the highest quality
pictures with less fl icker.
Consumers should note that not all high defi nition television sets
are fully compatible with this product and may cause artifacts to be
displayed in the picture. In case of 576 or 480 progressive scan picture
problems, it is recommended that the user switch the connection to
the “standard defi nition” output. If there are questions regarding our
TV set compatibility with this model 576p or 480p DVD player, please
contact our Customer Service Center.
Connecting to a TV (Using the component video jacks)
• Make the following setting.
On-screen display Select: Page
“PCM” or
“Bitstream”
“Digital Output”
Component
*P-Scan
(Progressive)
“Video out”
* Only for TV equipped with component
video input jacks which support the
progressive scan.
34
35
To audio input
To 2ch AUDIO OUT
(R: red, L:white)
Y VIDEO P B P R
HDMI OUT ANALOG COAXIAL DIGITAL R L
VIDEO OUT
AUDIO OUT
To Y video
input
To P video
input
B
To P video
input
R
Audio cable (not supplied)
Component video cable (not supplied)
OPTICAL OUT AV
S e t t i n g t h e v i d e o o u t p u t s i g n a l ( i n t e r l a c e d /
progressive)
You can set the video output signal for better picture
quality.
Press the SETUP button on the remote control and select
the Video option, then set the Video out to P-Scan. See
34 .
If your TV does not support the progressive scan format,
the picture will appear scrambled or blank. To return to
normal picture, turn off progressive scan (P-Scan) by
setting the Video out to Component mode.