Identifi cation of controls (continued), Operating with the remote control, Loading batteries – Toshiba XDE600 User Manual
Page 10

10
Introduction
Open the cover.
Insert batteries (R03/AAA size).
Make sure to match the + and – on the batteries to 
the marks inside the battery compartment.
Caution
• Never throw batteries into a fi re.
Notes
• Be sure to use R03/AAA size batteries.
• Dispose of batteries in a designated disposal area.
• Batteries should always be disposed of with the environment 
in mind. Always dispose of batteries in accordance with 
applicable laws and regulations.
• If the remote control does not operate correctly, or if the
operating range becomes reduced, replace both batteries 
with new ones.
• When necessary to replace batteries in the remote
control, always replace both batteries with new ones. 
Never mix battery types or use new and used batteries in 
combination.
• Always remove batteries from remote control if they are dead
or if the remote control is not to be used for an extended 
period of time. This will prevent battery acid from leaking into 
the battery compartment.
• Battery shall not be exposed to excessive heat such as
sunshine, fi re or the like.
Operating with the remote control
Point the remote control at the remote 
sensor and press the buttons.
Distance: About 7 m (23 feet) from the front of the
remote sensor
Angle:
About 30° in each direction of the front of the 
remote sensor 
* Do not expose the remote sensor of the DVD player
to a strong light source such as direct sunlight or 
other illumination. If you do so, you may not be able 
to operate the DVD player via the remote control.
Notes on the remote control
• Direct the remote control at the remote sensor of the DVD 
player.
• When using the remote control, press the buttons at
intervals of about 1 second to ensure the correct mode of 
operation.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or 
humid place.
• Do not spill water or put anything wet on the remote
control.
• Do not open the remote control.
2
Loading batteries
1
Identifi cation of Controls (continued)
