Toshiba M6363 - Manual (Page 69)

69
Engl
ish
CONTROLS AND FEATURES
e
Press B / b to go through the list adding the
details of the On Timer by using the number
buttons and
C / c to make selections.
Power On Time (only for DTV Clock On mode):
Set the time you prefer with the number buttons.
Repeat (only for DTV Clock On mode): Select the
desired On Timer operation (Once, Every Day,
Mon-Fri, Mon-Sat, Sat-Sun).
Input: Select a video input source (ATV, DTV Ant,
EXT 1, EXT 2, HDMI 1, HDMI 2, HDMI 3, HDMI 4
or PC).
Channel: Set the channel that will be tuned when
the television turns on.
NOTE: When an external input is selected in the
Input field, a channel cannot be selected.
Volume: Set the volume that will be applied when
the television turns on.
Time until Power On (only for DTV Clock Off
mode): Set the amount of time from now until the
TV turns on using the number buttons (maximum
of 12 hours).
f
Press
B
/
b
to highlight Done and press OK.
To cancel the On Timer:
a
In the On Timer menu, select Enable On Timer.
b
Press C / c to select Off.
c
Press B / b to highlight Done and press OK.
The television can be set to turn itself Off after a certain
length of time.
a
Press and
B
/
b
to highlight Timers icon.
b
Press
c
and
B
/
b
to highlight Sleep Timer and
press OK.
c
Use the number buttons to set the desired time.
For example, to switch the television off in one and
a half hours enter 01:30, or press
c
/
C
to
increase/decrease in steps of 10 minutes.
(Maximum time setting is 12 hours)
d
Press EXIT to finish.
e
To cancel the Sleep Timer, enter all zeros for the
above setting.
Energy Saving Settings
The TV will automatically turn itself off (Standby) after 4
hours, if you do not operate the TV either from the remote
control or the TV control panel.
a
Press and B / b to highlight Options icon.
b
Press
c
and
B
/
b
to select Power Management
and press OK.
c
Press
B
/
b
to select Automatic Power Down.
d
Press c and B / b to select On or Off and press
OK.
NOTE:
• This feature is set to On when Location is set to Home.
• 1 minute before switching to Standby, a Warning
message will appear.
• When the following features are set, the feature that is
set for the nearest time will function.
- Automatic Power Down
- Sleep Timer
- Auto shutdown after 1 hour of inactivity (after power on
by On Timer)
- No signal auto power off (after 15 minute of no signal)
The TV will automatically turn itself off after 15 minutes
when no signal is detected. You can change the setting to
Off for the following purposes:
• Low signal strength of analogue channel (no signal
detection)
• Only Audio L/R is connected to external input to listen to
music through the TV speakers.
a
In the Power Management menu, press B / b to
select No Signal Power Down.
b
Press
c
and
B
/
b
to select the item you want to
change and press c and B / b to select On or
Off.
NOTE:
• Default setting is all On.
• A warning message will appear 1 minute before turning
off.
Sleep Timer
Automatic Power Down
No Signal Power Down