Toshiba Qosmio G30 HD-DVD (PQG31) User Manual
Page 175
User’s Manual
9-13
Optional Devices
If you install a memory module that is not compatible with the computer, a
beep will sound when you turn on the power. If the incompatible module is
installed in slot A, there will be a long beep (1 second) followed by one
short beep (0.5 seconds), while if the incompatible module is in slot B, there
will be a long beep followed by two short beeps. In the event both modules
are incompatible, there will be a long beep followed by one short beep, a
pause, and then a long beep followed by two short beeps. In all instances
you should shut down the computer and remove the incompatible
module(s).
Installing a memory module
There are slots for two memory modules, one over the other. The
procedures are the same for installing either module.
1. Set the computer to boot mode and turn the computer’s power off.
Make sure the Power indicator is off. Refer to the
section in Chapter 3,
.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down and remove the battery pack. Refer to
, for details.
4. Loosen the screw securing the memory module cover. The screw is
attached to the cover to prevent it from being lost.
5. Slide your fingernail or a thin object under the cover and lift it off.
Removing the memory module cover
Use a #0 point Phillips screwdriver to remove and fasten the screws. Use
of an incorrect screwdriver can damage the screw heads.
Memory module
cover
Screw