Toshiba Qosmio G30 HD-DVD (PQG31) - Manual (Page 128)

7-8 User’s Manual
HW Setup
Starting the BIOS Setup Program
1. Switch on your computer while pressing the Esc key.
If “Password =” is displayed, enter either the Supervisor Password, if
one is set, or the user password and press the Enter key.
Please refer to Chapter 6, the TOSHIBA Password Utility , for details
about the user password.
The “Check system. Then press [F1] key.” message is
displayed.
2. Press the F1 key.
The BIOS setup program will start up.
Ending the BIOS Setup Program
Save the changes and end the program.
1. Press the End Key.
The “Are you sure? (Y/N) The changes you made will
cause the system to reboot.” message is displayed.
2. Press the Y key.
The configured settings are saved and the BIOS setup program ends.
The computer may reboot depending on the settings that were
modified.
Ending the BIOS Setup Program Halfway
The configuration settings can be terminated halfway without saving any of
the changes made.
1. Press the Esc key.
The “Exit without saving? (Y/N)” message is displayed.
2. Press the Y key.
The BIOS setup program will end.
Enhanced C-States
This feature enables or disables the Enhanced C-States.
The configuration for the Enhanced C-States is carried out in the BIOS
setup program. This setting is displayed on the first page of the setup
screen.
Enabled This lowers the power consumption (Default).
Disabled This does not lower the power consumption.