Controlling the rest of your system 31, Setting up the remote control 31, 09 controlling the rest of your system – Pioneer VSX-D510 User Manual
Page 31: Setting up the remote control, Recalling preset codes, 1 press, At the same time to select the preset mode, 2 press the, Button for the component you want to control, 4 press

31
En
09
Controlling the Rest of Your System
1 Press
REMOTE SET UP
and
1
at the same
time to select the preset mode.
The LED on the remote control starts to blink.
To cancel the preset mode at any time
Press
REMOTE SET UP
.
2 Press the
MULTI CONTROL
button for the
component you want to control.
Each button can be set to control one of the following
components
DVD/LD
: DVD or LD player
TV/SAT
: TV or Satellite tuner
VCR/DVR
: VCR or Digital Video Recorder
CD
: CD player
CD-R/TAPE/MD
: CD Recorder or Tape deck or MD player
TV CONT
: TV or Cable TV tuner
The LED lights steadily.
3 Point the remote control toward the
component to be controlled, enter the 3 digit
preset code.
When you enter the preset code, the remote control
emits a power ON/OFF signal. If the component
turns ON or OFF, you have entered the proper code.
If the component does not turn ON or OFF and there
is more than one preset code, try inputting another
code (starting again from step 2).
Some manufacturers use several sets of remote
control signals and the first code may not correspond
to your component.
Repeat steps 2 through 3 to recall preset codes for
as many components as necessary.
4 Press
REMOTE SET UP
to exit the preset
mode.
The remote control returns to the previous operation
mode.
MEMO
• When operating a Pioneer DVD/LD player, set the
preset code to “
111
” in the preset mode.
• TUNER cannot be preset.
1,4
2
1
3
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS
ATT
VOL
MENU
TOP
MENU
VOL
CH
2
DSP MODE MIDNIGHT 5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL
EFFECT
ENTER
FQ
FQ
ST
ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
TV CONTROL
FUNC
SIGNAL
SELECT
TEST
TONE
RECEIVER TUNER TV CONT
Î
1
2
3
4
1
¡
4
¢
7
8
3
5
6
7
8
9
0
SOURCE CLASS MPX BAND
10 DISC
CHANNEL
DISPLAY RF ATT
LED
Setting Up the Remote Control
Recalling preset codes
The following steps show you how to recall preset codes
for each
MULTI CONTROL
button. Once the preset code
is assigned, pressing the button will automatically set the
remote to operate the respective component.
MEMO:
• Refer to “Preset Code List” on pages 35-37 for the
components and manufacturers available.
• Refer to “Controlling the Rest of Your System” on
pages 33-34 for detailed explanations on how to
operate your other components.