Pioneer VSX-D510 - Manual (Page 24)

24
En
07
Finding a Station
The following steps show you how to tune in to FM and
AM radio broadcasts using the automatic (search) and
manual (step) tuning functions. If you already know the
exact frequency of the station you want to listen to, see
Tuning Directly to a Station below. Once you are tuned
to a station you can memorize the frequency for recall
later—see Memorizing Stations on page 25 for more on
how to do this.
Using the Tuner
1 Press the MULTI CONTROL TUNER button
on the remote control or turn the MULTIJOG
DIAL on the receiver to select the tuner
mode.
2 Use the BAND button to change the band
(FM or AM), if necessary.
Each press switches the band between FM and AM.
3 Tune to a station.
Automatic tuning
To search for stations in the currently selected band,
press and hold either the
FQ. + or FQ. – button for
about a second (on the front panel use the TUNING
+/– buttons). The receiver will start searching for the
next station, stopping when it has found one. Repeat
this step to search for other stations.
Manual tuning
To change the frequency one step at a time, press the
FQ. + / FQ. – (
5∞) buttons (on the front panel use
the TUNING +/– buttons).
High speed tuning
Press and hold the
FQ. + or FQ. – button for high
speed tuning, releasing the button once the desired
frequency is reached (on the front panel use the
TUNING +/– buttons).
2
1
MPX
3
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS
ATT
VOL
MENU
TOP
MENU
VOL
CH
2 DSP MODE MIDNIGHT 5.1CH
CD-R/
TAPE/MD
CHANNEL
SELECT
CHANNEL
LEVEL EFFECT
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
TV CONTROL
FUNC
SIGNAL
SELECT
TEST
TONE
RECEIVER TUNER TV CONT
1 2 3 4
5 6 7 8
9 0
SOURCE CLASS MPX BAND
10 DISC
CHANNEL
DISPLAY RF ATT
RF ATT mode
If the radio signal is too strong and/or the sound is
distorting press the
RF ATT button to attenuate (lower)
the radio signal input and reduce the distortion.
MPX mode
If there is interference or noise during a FM radio
broadcast, or the radio reception is weak, press the
MPX
button to switch the receiver into mono reception mode.
This should improve the sound quality and allow you to
enjoy the broadcast.
RF ATT
LOUDNESS FUNCTION MUTING
RECEIVER
D.ACCESS
VOL
MENU
TOP
MENU
VOL
CH
ENTER
FQ
FQ
ST ST
FL
DIMMER
REMOTE
SETUP
MASTER
VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
TV CONTROL
FUNC
SOURCE CLASS MPX BAND
CHANNEL
DISPLAY RF ATT
RF ATT