Pioneer DEX-P99RS - Manual (Page 42)

3 Push MULTI-CONTROL right.
Are You Sure? appears in the display.
4 Press MULTI-CONTROL to reset audio
functions.
Complete appears in the display and audio
functions are reset.
# To cancel this function on the way, press B.
Switching the sound
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE
or ATT are displayed and no audio adjust-
ment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Use MULTI-CONTROL to select Mute in
the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Press MULTI-CONTROL to switch the tel-
ephone muting/attenuation.
Each press of
MULTI-CONTROL selects set-
tings in the following order:
20dB ATT (20 dB attenuation)
—TEL mute
(mute)
—10dB ATT (10 dB attenuation)
! 20dB ATT has a stronger effect than
10dB ATT.
Setting the polarity of the
door operation
Before using door mute function, it is neces-
sary to set the polarity of the door operation.
Check the polarity of the door opening opera-
tion, and set it correctly.
1 Use MULTI-CONTROL to select
Door mute 1 in the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Press MULTI-CONTROL to select setting.
Each press of MULTI-CONTROL selects set-
tings in the following order:
High (high)
—Low (low)
! If the polarity changes to + (positive) when
the door is opened, select High.
! If the polarity changes to – (negative) when
the door is opened, select Low.
Setting the door mute setting
Sound from this system is muted or attenu-
ated automatically when the vehicle door is
opened.
! Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1 Use MULTI-CONTROL to select
Door mute 2 in the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Press MULTI-CONTROL to switch the
door muting/attenuation.
Each press of
MULTI-CONTROL selects set-
tings in the following order:
OFF (off)
—20dB ATT (20 dB attenuation)—
MUTE (mute)
Switching the reverse mode
If you do not perform an operation for about
30 seconds, screen indications start to reverse,
and continue reversing every 10 seconds.
1 Use MULTI-CONTROL to select
Reverse mode in the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Press MULTI-CONTROL to turn the re-
verse mode on.
# To turn the reverse mode off, press
MULTI-CONTROL again.
# You can also turn on or off reverse mode by
pressing
B while this unit is turned off. For more
details, refer to Reverse mode on page 7.
Initial Settings
En
42
Section
04