Pioneer DEX-P99RS - Manual (Page 41)

2 Push MULTI-CONTROL left or right to
select the desired illumination color.
Each time
MULTI-CONTROL is pushed left or
right, the illumination color is selected in the
following order:
White (white)
—Red (red)—Amber (amber)—
Blue (blue)
—Green (green)—Custom (cus-
tom)
# If you select Custom, you can adjust the level
of three primary colors such as red, green and
blue. For details, Adjusting the illumination color
on this page.
3 Push MULTI-CONTROL up or down to
adjust the brightness level.
+1 to
–1 is displayed as the level is increased
or decreased.
Adjusting the illumination
color
You can create an illumination color by adjust-
ing the level of the three primary colors, which
are red, green and blue.
! This function can be used only when
Custom is selected in Illumination 1.
1 Use MULTI-CONTROL to select
Illumination 2 in the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Push MULTI-CONTROL left or right to
select the color to adjust.
R (red)
—G (green)—B (blue)
3 Push MULTI-CONTROL up or down to
adjust the level of color.
4 to 0 is displayed as the level is increased or
decreased.
Setting the illumination
interlock
This unit
’s button illumination can be inter-
locked with either the ignition key or the vehi-
cle light switch. In this setting, you can select
the appropriate option.
1 Use MULTI-CONTROL to select ILL line
in the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Press MULTI-CONTROL to turn this func-
tion on.
When this function is on, the button illumina-
tion is interlocked with the vehicle light
switch.
When this function is off, the button illumina-
tion is interlocked with the ignition switch.
# To turn off, press MULTI-CONTROL again.
Correcting distorted sound
When listening to a CD or other source on
which the recording level is high, setting the
level of each frequency to high may result in
distortion. You can switch the digital attenua-
tor to low to reduce distortion.
! Sound quality is better at the high setting
so this setting is usually used.
1 Use MULTI-CONTROL to select
Digital ATT in the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Press MULTI-CONTROL to select the di-
gital attenuator level.
Pressing
MULTI-CONTROL repeatedly will
switch between High (high) and Low (low)
and that status will be displayed.
Resetting the audio functions
You can reset all audio functions.
1 Use MULTI-CONTROL to select
Audio Reset in the initial setting menu.
Refer to Adjusting initial settings on page 38.
2 Press MULTI-CONTROL.
Reset data? appears in the display.
Initial Settings
En
41
Section
04
Initial
Settings