Pioneer DEX-P99RS - Manual (Page 27)

Operation modes
This unit
’s 4-way network DSP lets you create
a 4-way multi-amp, multi-speaker system with
separate speakers for reproduction of high,
middle, low and ultra-low frequencies (bands),
each driven by a dedicated power amp. The 4-
way network mode provides network and time
alignment functions. These two functions are
essential for a multi-amp, multi-speaker sys-
tem to enable precise control over settings for
each frequency range.
Important
Even when the battery is disconnected or the mi-
croprocessor is reset, this unit
’s audio setting re-
mains in the memory. If you want to reset the
audio setting, refer to Resetting the audio func-
tions on page 41.
Note
If one subwoofer is used with this system, left
and right channel adjustment values, such as
time alignment and network settings, need to be
the same.
Adjusting the audio easily
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field effortlessly.
1 Using the position selector (POSI)
2 Auto TA and EQ (auto-time alignment and auto-
equalizing)
3 Using balance adjustment on the next page
( BAL)
Adjusting the audio finely
By carrying out the following settings/adjust-
ments in the order shown, you can create a fi-
nely-tuned sound field.
1 Adjusting the time alignment (TA2)
2 Adjusting network (NW 1, NW 2, NW 3)
3 Fine-adjusting equalizer curve (EQ 2)
Extra functions
These functions are helpful in adjusting the
sound to suit your system or your personal
preferences.
! Recalling or copying equalizer curves (EQ 1)
! Adjusting loudness (LOUD)
! Using the sound retriever (S.Rtrv)
! Adjusting source levels (SLA)
Introduction of audio
adjustments
1 Audio display
Shows the audio adjustment status.
1 Press MULTI-CONTROL to display the
main menu.
2 Use MULTI-CONTROL to select AUDIO.
Turn to change the menu option. Press to se-
lect.
3 Turn MULTI-CONTROL to select the
audio function.
Turn
MULTI-CONTROL to switch between the
audio functions in the following order.
BAL (balance adjustment)
—POSI (position se-
lector)
—NW 1 (network adjustment 1)—NW 2
(network adjustment 2)
—NW 3 (network ad-
justment 3)
—TA1 (time alignment setting)—
TA2 (time alignment adjusting)
—EQ 1 (copy-
ing/recalling the equalizer)
—EQ 2 (31-band
graphic equalizer)
—A.EQ (auto-equalizer on/
off)
—S.Rtrv (advanced sound retriever)—
LOUD (loudness) —SLA (source level adjust-
ment)
# When selecting FM as the source, you cannot
switch to
SLA.
# When selecting FLAT in EQ 1, you cannot
switch to
EQ 2.
# When selecting OFF in TA1, you cannot
switch to
TA2.
# To return to the display of each source, press
B.
Audio Adjustments
En
27
Section
03
Audio
Adjustments