Pioneer DEX-P99RS - Manual (Page 28)

Switching left and right
channel
You can adjust following functions for left and
right channel independently or commonly.
! Adjusting network (NW 1, NW 2, NW 3)
! Fine-adjusting equalizer curve (EQ 2)
1 Use MULTI-CONTROL to select the
audio function described above.
2 Press MULTI-CONTROL and hold to
switch between left/right independent
mode and left/right common mode.
Each pressing and holding
MULTI-CONTROL
selects left/right independent mode and left/
right common mode.
3 Press MULTI-CONTROL to select left
channel or right channel when left/right in-
dependent mode has been selected.
Each pressing
MULTI-CONTROL selects left
channel and right channel.
4 Adjust these functions as desired.
Using balance adjustment
You can select a balance setting that provides
an ideal listening environment in all occupied
seats.
1 Use MULTI-CONTROL to select BAL in
the audio function menu.
Refer to Introduction of audio adjustments on
the previous page.
2 Push MULTI-CONTROL left or right to
adjust left/right speaker balance.
Each time
MULTI-CONTROL is pushed left or
right, the left/right speaker balance moves to-
wards the left or right.
L 25 to R 25 is displayed as the left/right
speaker balance moves from left to right.
Using the position selector
One way to assure a more natural sound is to
clearly position the stereo image, putting you
right in the center of the sound field. The posi-
tion selector function lets you automatically
adjust the speakers
’ output levels and inserts
a delay time to match the number and posi-
tion of occupied seats.
1 Use MULTI-CONTROL to select POSI in
the audio function menu.
Refer to Introduction of audio adjustments on
the previous page.
2 Push MULTI-CONTROL left, right or up
to select a listening position.
Direction Display Position
Left Left Front seat left
Right Right Front seat right
Up Front Front seats
# To cancel the selected listening position, push
MULTI-CONTROL in the same direction again.
About the network function
The network function lets you divide the audio
signal into different frequency bands, and
then reproduce each of them through sepa-
rate speaker units.
You can then make precise adjustments to the
reproduced frequency band (with a low-pass
filter or high-pass filter), level, phase and other
parameters to match the characteristics of
each speaker unit.
Audio Adjustments
En
28
Section
03