Pioneer LX03 - Manual (Page 84)

Additional information 14
84
En
Resetting the system
Use this procedure to reset all system settings
to the factory default.
1 Press SETUP.
2 Select ‘Initialize’ then press
ENTER.
3 Select ‘All Init’ then press ENTER.
• Initialize OK? is displayed.
4 Press ENTER to confirm initialization.
The system will restart and all the system
settings should be reset.
• Note that following settings will be saved,
even if the receiver is unplugged.
Using the language code list
Some of the language options (see Language
settings on page 54) allow you to set your
preferred language from any of the 136
languages in the Language code list below.
1 Select ‘Other Language’.
2 Select either a code letter or a
code number.
3 Select a code letter or a code
number.
See the Language code list below for a
complete list of languages and codes.
Input function ‘HDMI 1’, ‘Digital 1’, etc.
Listening mode ‘Auto’, ‘Action’, etc.
Sound Retriever ‘Retriever On’ or
‘Retriever Off’
Sound Field Sound Field
Tone controls Bass, Treble, Quiet,
Midnight
Bass Mode Bass Mode
Dialogue Enhancement Dialogue
Acoustic Calibration EQ MCACC EQ
Sound Delay Sound Delay
Center Width Center Width
Dimension Dimension
Panorama Panorama
Channel Level Channel Level
Speaker Distance Distance
Dynamic Range Control D.R.C.
Dual Mono Dual Mono
Virtual Surround Back Virtual SB
LFE Attenuator LFE ATT
CD Type CD Type
SETUP
ENTER
ENTER
ENTER
Display Mode Display Mode
Line Output Line Output
TV Input TV Input
HDMI Audio HDMI Audio
HDMI Control mode HDMI Ctrl
Auto Delay Auto Delay
Storing stations -
LX03_En.book 84 ページ ２００８年６月２４日 火曜日 午後６時１分