Pioneer LX03 - Manual (Page 42)

iPod/USB playback 07
42
En
Important
If an error message lights in the front panel
display, try following the points below:
Switching the iPod controls 1
You can switch over the iPod controls between
the iPod and the unit.
1 Press to switch the iPod controls. 2
This enables operation and display on your
iPod, and this unit’s remote control and OSD
become inactive.
2 Press again to switch back to the
receiver controls.
iPod is a trademark of Apple Inc., registered in
the U.S. and other countries.
Using the USB interface
It is possible to listen to two-channel audio
3
and watch JPEG files using the USB interface
on the front of this unit. Connect a USB mass
storage device
4 as shown below.
1 With the system switched on, press
USB.
Make sure your TV is on and set to the correct
video input.
2 Connect your USB memory device.
Symptom What it means
Error I1 There is a problem with the signal path
from the iPod to the unit. Switch off the
unit and reconnect the iPod to the unit.
If this doesn’t seem to work, try resetting
your iPod.
Error I2 The software version being used with
the iPod needs to be updated. Update
the software being used with the iPod
(please use the latest iPod software
versions later than the iPod updater
2004-10-20).
Error I3 The iPod that is not supported is
connected. Check whether the iPod was
supported by this unit (page 40).
When the iPod software version is too
old, update the iPod software to the
latest version.
Error I4 When there is no response from the
iPod, update the iPod software to the
latest version. If this doesn’t seem to
work, try resetting your iPod.
iPod Error The power requirements of the iPod are
too high for this unit.
No Music
Track There are no playable songs currently
stored in the iPod. Input some music
files compatible with iPod playback.
No Track When there are no tracks in the
category selected on the iPod. Select a
different category.
Note
1 You cannot use this function, when an iPod of fifth generation or iPod nano of first generation is connected.
2 When this function is set, iPod images cannot be played on this unit.
3 This includes playback of WMA/MP3/MPEG-4 AAC files (except files with copy-protection or restricted playback).
4 • Compatible USB devices include external magnetic hard drives, portable flash memory (particularly keydrives) and digital
audio players (MP3 players) of format FAT16/32. It is not possible to connect this unit to a personal computer for USB playback.
• Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no
responsibility for any loss of data that may occur when connected to this unit.
• With large amounts of data, it may take longer for the system to read the contents of a USB device.
CTRL
CTRL
USB
LX03_En.book 42 ページ ２００８年６月２４日 火曜日 午後６時１分