Listening to the radio 08 – Pioneer LX03 User Manual
Page 46

Listening to the radio
08
46
En
Changing the noise cut mode
If you find that the AM sound quality is bad
even after trying the above, you may be able to
improve it using a different noise cut mode.
Just choose the one that sounds best.
1
Press after tuning to an AM radio
station.
2
Select ‘Tuner Setup’ then press
ENTER.
3
Choose ‘Noise Cut’ then press
ENTER.
4
Select a Noise cut mode (1, 2 or 3)
then press ENTER.
Memorizing stations
This system can memorize up to 30 stations,
stored in three banks, or classes (A, B and C) of
10 stations each.
1
Tune to an FM or AM radio station.
Select mono or auto-stereo reception (FM) or
the Noise Cut mode (AM) as necessary. These
settings are saved along with the preset.
2
Press T.EDIT.
3
Press to select one of the three
classes, then press ST +/– to select the station
preset you want.
You can also use the number buttons to select
a preset.
4
Press ENTER.
After pressing ENTER, the preset class and
number stop blinking and the system
memorize station.
Listening to station presets
You will need to have some presets stored to do
this.
1
Press to select the class in which the
channel is stored.
Press repeatedly to cycle through classes A, B
and C.
2
Select the station preset you
want.
• You can also use the number buttons on
the remote control to recall the station
preset.
SETUP
ENTER
ENTER
ENTER
T.EDIT
CLASS
ENTER
CLASS
ST
ST
LX03_En.book 46 ページ 2008年6月24日 火曜日 午後6時1分