Pioneer CT-L77 - Manual (Page 36)

7 Using the Tape Deck
36
Note: If the recorder has to switch the side of the tape half way through a track,
recording will start again on the other side from the beginning of the same track. This
means you don't get a single track spread over two sides of a tape.
2 Press MD to switch to the MD recorder.
3 Load the MD you want to record.
See page 11 of the MD manual for detailed instructions on loading discs.
If the disc has started playing, press
&.
4 If you want to record just one track, select
the track using the
$ and › buttons.
5 Press TAPE REC.
The tape deck goes into record-pause mode, waiting for you to start the MD
recorder.
6 Press MD to start the MD playing.
Recording starts automatically with the MD.
Once the track or disc has finished, the tape deck goes back into record-pause
mode—press
& to fully stop recording.
Should you want to stop recording before the track/disc has finished playing,
simply press
& any time during the recording.
Recording Other Sources
Usually, when recording a CD or MD, the synchro-recording feature is the easiest way
to do it. However, if you want to record from the tuner or from a component connected
to the AUX/CD-R inputs, you'll need to start and stop the recording manually.
1 Follow steps 1–4 of Automatically
Recording a CD on page 34.
❖ Load a cassette
❖ Set the record direction
❖ Set the reverse mode
❖ Switch Dolby NR on/off.
AUX/CD-R SOUND DISPLAY SET MD TAPE TIMER/
CHARACTER
&
CANCEL REC
$
! —
›
+ ⁄
VOL
STANDBY/ ON
TAPE REC TAPE
AUX/CD-R TUNER
7
Cassette loaded and direction,
reverse mode and Dolby NR all
set up
With the MD stopped, the
display shows the number of
tracks and the playing time
The synchro indicator lights
and the recording indicator
flashes
After starting MD playback, the
recording indicator lights
steadily