Checking the location on the map, Checking the calculated route, The basic flow of creating your route – Pioneer AVIC-F10BT User Manual
Page 31: Setting a route to your destination
CAUTION
For safety reasons, these route-setting functions
are not available while your vehicle is in motion.
To enable these functions, you must stop in a
safe place and put on the handbrake before set-
ting your route.
p Some information regarding traffic regula-
tions depends on the time when the route
calculation is performed. Thus, the infor-
mation may not correspond with a certain
traffic regulation when your vehicle actually
passes through the location in question.
Also, the information on the traffic regula-
tions provided will be for a passenger vehi-
cle, and not for a truck or other delivery
vehicles. Always follow the actual traffic
regulations when driving.
The basic flow of creating
your route
1
Park your vehicle in a safe place, and
apply the handbrake.
2
Display the
“Top Menu” screen.
3
Select the method of searching for your
destination.
= For details, refer to Searching for and select-
ing a location on page 38.
4
Enter the information about your desti-
nation to calculate route.
5
Confirm the location on the map.
= For details, refer to Checking the location on
6
The navigation system calculates the
route to your destination, and then shows
the route on the map.
7
Check and decide the route.
= For details, refer to Checking the calculated
8
Your navigation system sets the route
to your destination, and the map of your
surroundings appears.
9
After releasing the handbrake, drive in
accordance with navigation guidance.
Checking the location on
the map
After searching for the destination, the
“Loca-
tion confirmation screen
” appears.
Location confirmation screen
% Touch [OK].
The destination is set, and then route calcula-
tion starts.
p If you press MODE button during route cal-
culation, the calculation is cancelled and
the map display appears.
# Touch [Scroll].
The map display changes to the scroll mode. You
can fine-tune the location in the scroll mode, and
then you can set the location as your destination
or do various operations.
# Touch [Waypoints].
The location is added to the
“Waypoints List”
screen.
p If a destination is not set, [Waypoints] is
not available.
Checking the calculated route
After the destination is set, route calculation
starts.
Setting a route to your destination
Engb
31
Chapter
06
Setting
a
route
to
your
destination