BT 1050 - Manual (Page 16)

12
Using the Freestyle 1050
answering machine
Outgoing messages
Your Freestyle 1050 can digitally record up to
14 minutes of messages, with each incoming
message lasting a maximum of 2 minutes.
The outgoing message is the message a caller
hears when your Freestyle 1050 answers a call.
The Freestyle 1050 has a pre-recorded outgoing
message which announces. . .
“Hello, your call cannot be taken at the moment,
so please leave your message after the tone.”
You can record your own outgoing message to
replace the pre-recorded message.
If you record your own message, the pre-recorded
message is automatically removed and stored in
the memory, in case you wish to reinstate it; see
how to delete your outgoing message on page 13.
Any outgoing message you record can be up to
2 minutes long, but you should keep it short to
allow more time for recording of incoming calls.
NOTE
To record your own outgoing message, speak clearly,
15 to 20cm from the built-in microphone.
Display Definition
(Blank) Power off.
— — — Power up or reset.
— Power on – answer off mode.
0-30 Answer-on mode, 0-30 messages.
P (flashing) Message paused.
r (flashing)
Message recording (memo, outgoing
message or incoming message).
A (flashing) Remote access in progress.
F (flashing) Memory full.
t or 2 to 9 Setting or reading answer delay.
d (flashing) 1471 function in progress.
E (flashing) Error.
8-0 Counting down.
Message display
ANSWERING MACHINE