beautypg.com

Mains power adaptor, Electrical storm warning – BT 1050 User Manual

Page 10

background image

6

Mains power adaptor

The Freestyle 1050 must only be used with the

adaptor supplied.

Using any other adaptor will invalidate the approval

given to this apparatus.

When fully charged and in good condition,

the handset battery will provide up to 6 hours

continuous talk time or 72 hours standby.

If the handset battery is running low, the

BATTERY LOW

light will f lash every 10 -15 seconds.

If you are making a call and the handset

battery is running low, the phone will beep every

10 -15 seconds.

Place the handset on the base unit to recharge.

6

Charge the handset batter y for at

least 12 hours

When you first use your Freestyle 1050, the
rechargeable batteries in the handset need
charging for 12 hours.

Place the handset on the base unit face down,
ensuring the contacts are touching.

The

CHARGING

light on the base unit comes ON.

After the handset has been charged for 12 hours,
your phone is ready for use.

As a rule, placing the handset on the base unit
overnight will keep the batteries fully charged
for all normal use.

The

CHARGING

light remains on until the

handset is removed from the base unit.

SETTING UP

4

Plug the mains adaptor cord into

the back of the base unit

5

Plug the 3 pin adaptor into the

mains power socket and switch on

PHONE LINE

12V AC

To prevent the cable being pulled out by
accident, route it through the channel on the
underside of the base.

Electrical storm warning

During periods of electrical storm, you are

advised to disconnect your apparatus because

damage may occur.

If a fault occurs during the 12-month warranty

period and it is due to accidental or wilful damage

(including lightning and electrical damage),

BT will not replace or repair free of charge.

Your Freestyle 1050 begins the set up procedure.
– the message counter flashes ‘–

–’.

– the message counter then flashes 0.
– the pre-set outgoing message is ready to use.