Pioneer VSX-2021 - Manual (Page 53)

En 53
09 Using other functions
Checking your system settings
Use the status display screen to check your
current settings for features such as surround
back channel processing and your current
MCACC preset.
1 Press to the receiver operation
mode, then press STATUS to check the
system settings.
The front panel display shows each of the fol-
lowing settings for three seconds each: Input
Source
d Sampling Frequency d MCACC
preset d ZONE 2 input d ZONE 3 input d
HDMI OUT.
2 When you’re finished, press STATUS
again to switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this. Set MULTI-ZONE to
MULTI ZONE OFF.
! Disconnect the iPod and USB memory device
from the receiver beforehand.
! Set the Control with HDMI to OFF (see HDMI
Setup on page 45 ).
1 Switch the receiver into standby.
2 While holding down ENTER on the
front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select ‘RESET’ using PRESET k/l,
then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
! Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting Default
Digital Video Converter ON
SPEAKERS SB/FH
Speaker System
Normal
(SB/FH)
Speaker Setting
Front SMALL
Center SMALL
FH/FW SMALL
Surr SMALL
SB SMALLx2
SW YES
Surround Position IN REAR
Crossover 80 Hz
X-Curve OFF
DIMMER
Medium
bright
Inputs
See Input function default and possible settings on
page 28 .
HDMI
HDMI Audio
Amp
HDMI output
HDMI OUT
ALL
Control ON
Control Mode ALL
Display Power Off YES
Audio playback
Power On Level
LAST
Volume Limit OFF
Mute Level FULL
Phase Control ON
Setting Default
Auto Sound
Retriever
iPod/USB,
HOME MEDIA
GALLERY,
ADAPTER PORT
input function
ON
Other input
functions
OFF
Sound Delay 0.0 frame
Dual Mono CH1
DRC AUTO
SACD Gain 0 dB
LFE Attenuate 0 dB
Auto delay OFF
Digital Safety OFF
Effect Level
ExtendedStereo 90
Other modes 50
2 PL II Music
Options
Center Width 3
Dimension 0
Panorama OFF
Neo:6 Options Center Image
Neo:6
CINEMA: 10
Neo:6
MUSIC: 3
2 PL IIz Options Height Gain MID
All Inputs
Listening Mode
(2 ch/multi ch) AUTO
SURROUND
Listening Mode
(Headphones)
STEREO
See also Setting the Audio options on page 48 for
other default DSP settings.
MCACC
MCACC Position Memory
M1:
MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 3.00 m
Standing Wave
(M1 to M6)
ATT of all chan-
nels/filters
0.0 dB
SWch Wide Trim 0.0 dB
Setting Default
EQ Data (M1
to M6)
All channels/
bands
0.0 dB
EQ Wide Trim 0.0 dB