Network setup – Pioneer BCS-FS505 User Manual

Page 28

Installation

Network Setup

Before setting the wired network, you need to
connect the broadband internet to your home
network.

If there is a DHCP server on the local area
network (LAN) via wired connection, this player
will automatically be allocated an IP address.
After making the physical connection, a small
number of home networks may require the
player’s network setting to be adjusted. Adjust
the [NETWORK] setting as follows.

1. Select [Connection Setting] option in the

[Setup] menu then press ENTER (

2. Use U/u/I/i to select the IP mode

between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.

NOTE

If there is no DHCP server on the network and you
want to set the IP address manually, select [Static]
then set the [IP Address], [Subnet Mask], [Gateway]
and [DNS Server] using

U/u/I/i and numerical

buttons. If you make a mistake while entering a
number, press CLEAR to clear the highlighted part.

3. Select [OK] and press ENTER ( ) to apply

network settings.

4. The player will ask you to test the network

connection. Select [OK] and press ENTER
(

) to complete the network connection.

5. If you select [Test] and press ENTER ( )

at step 4 above, the network connection
status is displayed on the screen.
You can also test it on the [Connection
Status] in the [Setup] menu.

HB485-DB.BDEUPPK_ENG.indd 28

2010-05-18 1:35:52