Component video connection, 21 installation, Installation – Pioneer BCS-FS505 User Manual

Page 21: Player

Installation

NOTE

• Changing the resolution when the connection

has already been established may result in
malfunctions. To solve the problem, turn off the
player and then turn it on again.

• When the HDMI connection with HDCP is not

verifi ed, TV screen is changed to black screen.
In this case, check the HDMI connection, or
disconnect the HDMI cable.

• If there is noise or lines on the screen, please

check the HDMI cable (length is generally
limited to 4.5 m and use a high speed HDMI
cable (version 1.3).

• If a connected HDMI device does not accept the

audio output of the player, the HDMI
device’s audio sound may be distorted or may
not output.

• When you use HDMI connection, you can

change the resolution for the HDMI output.
(Refer to “Resolution Setting” on page 22.)

• Select the type of video output from the HDMI

OUT jack using [HDMI Color Setting] option on
the [Setup] menu (see page 33).

• When you connect a HDMI or DVI compatible

device make sure of the following:
- Try switching off the HDMI/DVI device and this

player. Next, switch on the HDMI/DVI device
and leave it for around 30 seconds, then switch
on this player.

- The connected device’s video input is set

correctly for this unit.

- The connected device is compatible with

720x576p (480p), 1280x720p, 1920x1080i or
1920x1080p video input.

• Not all HDCP-compatible HDMI or DVI devices

will work with this player.

- The picture will not be displayed properly with

non-HDCP device.

- This player does not playback and TV screen is

changed to black screen.

Component Video Connection

Connect the COMPONENT VIDEO OUT jacks on
the player to the corresponding input jacks on
the TV using Y Pb Pr cables. You can hear the
sound the through the system’s speaker.

Component Connection

Player

Green
Blue
Red

COMPONENT

VIDEO

INPUT

OUTPUT

AUX

VIDEO

Player

Green
Blue
Red

NOTE

When you use COMPONENT VIDEO OUT
connection, you can change the resolution for the
output. (Refer to “Resolution setting” on page 22.)

HB485-DB.BDEUPPK_ENG.indd 21

2010-05-18 1:35:50