Pioneer VSA-E08 - Manual (Page 49)

OPERA
TION
OPERA
TION
49
En
Basic Playback
Adjusting Bass and Treble (Tone Control)
You can use BASS +/– or TREBLE +/– buttons to adjust the low and high frequencies for each individual set of
speakers. If the amplifier is in STEREO mode you can only adjust the FRONT speakers. In a surround mode
(STANDARD, ADVANCED THEATER, etc.) you can adjust the FRONT, CENTER, SURROUND and SURROUND
BACK speakers. The TONE button can also be used to bypass the tone circuitry (see p.23).
memo
Listening in LOUDNESS Mode
The LOUDNESS mode allows you to boost the bass in a signal. It is useful for listening to music at low volumes.
Press the LOUDNESS button on the
remote control’s Amplifier MAIN
screen or on the front panel.
Each press switches LOUDNESS mode on or off.
dB
STEREO LOUDNESS SIGNAL
SELECT
ANALOG SP A
AUTO
VOLUME
• You can’t use the LOUDNESS mode with the
THX or MULTI CH IN modes.
• If you press LOUDNESS when in DIRECT mode
the reciever switches to STEREO mode.
memo
Amplifier MAIN SUB
DSP STEREO
THX
ADVANCED
THEATER
EFFECT
STANDARD
MIDNIGHT
LOUDNESS
MULTI CH
IN
SIGNAL
SELECT
DIGITAL
NR
/ dts / MPEG
LOUDNESS
• The tone control can be adjusted in a range of
±6 dB.
• The tone control cannot be adjusted in THX,
MULTI CH IN.
• If the amplifier is in DIRECT mode and you
press the TONE button, TONE BYPASS will
appear in the display, letting you know that you
can't change the tone in DIERCT mode. Another
press cancels DIRECT mode.
LOUDNESS
CH
SELECT
TONE
SPEAKER
A/B
Amplifier MAIN SUB
TREBLE
SYSTEM
SETUP
CH
LEVEL
INPUT
ATT.
BASS
FL
DIMMER
TAPE 2
MONITOR
3 3
1
TREBLE BASS
CHANNEL SELECT TONE
1 Press the TONE button on the
remote control's Amplifier or front
panel to put the amplifier in tone
adjust mode.
TONE: ON should appear in the display. If TONE:
BYPASS appears, press the button again to get
TONE:ON the tone adjust mode.
2 Press the CH SELECT button on the
remote control's Amplifier or
CHANNEL SELECT button on the
front panel to cycle through the
different tone adjust channels.
The button cycles though the possibilities in the
following order:
TONE Front TONE Center
TONE SurBack TONE Surr.
3 Use the BASS or TREBLE (+/–)
buttons to adjust the low or high
frequencies of each channel.
Display when using the TONE +/- buttons.
dB
STEREO SIGNAL
SELECT
ANALOG SP A
VOLUME
A few seconds after you finish adjusting the tone the
amplifier will revert to the sound mode it was in at the
begining of the process.
MAIN
SUB