Pioneer VSA-E08 - Manual (Page 36)

36
En
3 Using the remote control display,
follow the instructions below to
adjust the speaker levels so that you
hear the test tone at the same
volume from each speaker when
seated in your normal listening
position.
NOTE : The volume of the subwoofer tends to sound
lower than it actually is. You may need to adjust the
level after testing with an actual soundtrack.
I n AUTO mode
1 Use the +/– (or 5˜∞) buttons to adjust the level of
the speaker outputting the test tone. The tone will
automatically switch between speakers after
sounding for 2-3 seconds.
2 Adjust the level of all speakers.
In MANUAL mode
1 Use the +/– (or 5˜∞) buttons to adjust the level of
the first (the front left) speaker.
2 Press the button on the touch panel for the next
speaker.
3 Repeat 1 and 2 for each speaker.
If you are using a Sound Pressure Level (SPL)
meter
Take the readings from your main listening position
and adjust the level of each speaker to 75 dB SPL (C-
weighted/slow model).
You can use the 5˜∞ buttons at the bottom of
the remote control instead of the +/– buttons.
4 When all the speaker levels have
been set, select SETUP OK to return
to the SYSTEM SETUP MENU.
The display on the amplifier will say RESUME and the
MASTER VOLUME will return to its original position.
dB
STEREO SIGNAL
SELECT
ANALOG SP A
AUTO
VOLUME
Next, proceed to CROSSOVER NETWORK below.
Note that it is also possible to set channel levels
temporarily. Go to the AMPLIFIER SUB screen and press
CH LEVEL. Then follow the same procedure as explained
on this page. This function is designed to be used when
you want to change the levels temporarily to hear one
speaker louder. Using this method you can set speaker
levels in different modes, such as 2/dts, STEREO, and
each DSP mode, independently. You should return the
settings to their original state when done. Doing the set up
procedures on this page will erase any temporary/
independent level settings that have been made.
memo
memo
3
4
5˜∞ buttons
ENTER
DVD/LD
TV/SAT
VCR1
VCR2
STANDBY/ON
BACK LIGHT
on/off
AUTO
T.TONE
MANUAL
T.TONE
AUTO
T.TONE
MANUAL
T.TONE
Initial Set Up