Pioneer PDP-S39 - Manual (Page 4)

English
4
5 Fix the speaker to the mounting
fittings.
Use the supplied screws to fix the speaker to the
mounting fittings as shown below (3 locations).
NOTE:
Do not use the screw hole located on the underside of the
mounting fittings to fix the speaker.
When using the hung on wall unit :
First install the Plasma Display on the wall with only the
speaker mounting fittings and speaker cable attached to the
display, and then attach the speaker.
1 Connect the speaker cable to the speaker terminal.
This illustration shows the PDK-TS12 table top stand.
2 Place the speaker on the speaker mounting fittings
and then tighten from below using the screws provided
(3 locations).
CAUTION
If you want to move the Plasma Display unit, make sure
that you remove the speaker first.
In addition, do not move the display holding on to the
mounting fittings. This can result in injury or damage to
the unit.
SRD1303A_01-07/En 6/16/05, 7:04 PM 4