Pioneer PDP-S39 - Manual (Page 3)

3
English
English
INSTALLATION ON THE PLASMA
DISPLAY
Perform installation according to the following steps 1 to 5.
NOTE:
Before attaching the speaker, please attach the PDK-TS12
table top stand (or another Pioneer Plasma Display stand)
to the Plasma Display unit.
1 Attach the speaker mounting fittings
to the rear of the Plasma Display.
Note:
It may be necessary to use a short screwdriver depending
on the stand used.
2 Connect the supplied speaker cables
to the back of the Plasma Display.
See the following page (P.5) for more detailed information
on connecting speaker cables.
3 Connect the other end of the speaker
cables to the speakers.
See the following page (P.5) for more detailed information
on connecting speaker cables.
4 Mount the speakers onto the
speaker mounting fittings.
To avoid damaging the stand, cover it with the protective
wrapping that covered the stand.
Protective wrapping (the PDK-TS12 table top stand only)
Carefully, mount the speaker onto the mounting fittings.
This diagram depicts
the PDK-TS12 table top
stand.
1 Attach the fittings for right and left sides to the Plasma
Display as shown. The diagram below depicts the right
side of the Plasma Display.
Tighten the upper screws first and then tighten the
lower screws.
2 Attach the center fitting to the Plasma Display as shown.
Tighten the right side screw first and then tighten the
left side screw.
SRD1303A_01-07/En 6/16/05, 7:04 PM 3