Pioneer PDP-428XD - Manual (Page 83)

Additional information 15
83
En
English
If the following error codes appear on the screen, check the corresponding items in the table.
• No sound. • Check if the connections are properly made between the plasma television and the device that
supports the HDMI Control functions. (See page 74.)
• Check if you have entered the settings properly for “HDMI Control Setting”. (See page 76.)
• Check if you have an HDMI controlled AV system connected to one HDMI terminal and the
recorder or player connected to another HDMI terminal on the plasma television. When
connected this way, audio out from the recorder/player does not go through the plasma television
SPDIF terminal resulting in no sound to the AV system. When using an AV system and recorder
or player, be sure to connect the recorder or player to the AV system input terminal.
•An error message “The device
cannot be operated. Please check
the connection.” appears. • Check if the connections are properly made between the plasma television and the device that
supports the HDMI Control functions. (See page 74.)
• Check if you have entered the settings properly for “HDMI Control Setting”. (See page 76.)
OTHER
• POWER ON indicator or
STANDBY indicator is quickly
flashing. • Internal protective circuits may have been activated. First turn off a on the plasma television, and
then turn the power on by pressing a again after waiting one minute or more. If the indicator is
still flashing, unplug the plasma television’s power cord from the power outlet. Wait one to two
minutes then plug in the plasma television again. If this does not solve the problem, contact a
Pioneer Service Center. These are listed on your warranty card for each country. Alternatively,
check the Pioneer Web site (see back cover) for contact details.
• An external device connected to
the USB terminal does not
operate. • Check if the device is connectable to the display. (See page 65.)
• Re-insert the USB cable. (See page 65.)
• For connection, use a USB cable shorter than 5 m. (See page 65.)
• Check if the USB cable is properly connected. (See page 65.)
• First turn off
a on the plasma television and then turn it on again in order to check if the external
device works correctly.
• Check if the external device works correctly after the USB device was restarted.
• Check if the digital still camera is in the viewing mode.
• Refer to the instruction manual for the digital still camera.
• Photo data stored in digital still
cameras cannot be read through
the USB interface. • Check if the device is connectable to the display. (See page 65.)
• Check if the digital still camera turns on.
Code Message Check
SD04 and SD11 Powering off. Internal temperature too high.
Check temperature around PDP. Check if the ambient temperature of the plasma television is
high.
SD05 (PDP-508XD)
Internal protection circuit turns the system off.
Is there a short in speaker cable?
(PDP-428XD)
Internal protection circuit turns the system off.
Check the speaker cable connections between the plasma
television and the speakers.
Contact a Pioneer Service Center. These are listed on your
warranty card for each country. Alternatively, check the
Pioneer Web site (see back cover) for contact details.
Problem Possible solution
PDP-508XD.book Page 83 Thursday, April 26, 2007 2:34 PM