Pioneer AVIC-85DHV-2 - Manual (Page 11)

9
Chapter
1
Setting the Remote Contr
ol and Names of Eac
h P
a
rt
Chapter
1
Setting the Remote Control and Names of Each Part
Preparing the Remote Control
You generally use the Remote Control to operate the Navigation System. Before using the
Remote Control, set the dipswitches and insert the batteries as described in the following sec-
tions.
■Selecting dipswitches
When you remove the battery cover of the Remote Control and remove the batteries, you will
see the dipswitches as shown in the following illustration. You can set each dipswitch using
the tip of a ballpoint pen.
Setting Switch 1 and 2
Set depending on the equipment being combined. When using an AV master unit, use setting
C or D.
Setting A : When combining with AVH-P6400CD, AVH-P6400R or a display which has
26 pin RGB input terminal.
Setting B : When using with a display other than those above (AVX-P7000CD, AVX-7000,
AVD-W8000, AVD-W6000, AVD-W6010, AVX-7300, AVX-P7300DVD etc.)
Setting C : When using with an AVM-P8000R or AVM-P9000R.
Setting D : When using with an AVM-P7000R.
Switch 1 Switch 2
Setting A : OFF OFF
Setting B : OFF ON
Setting C : ON OFF
Setting D : ON ON
ON
ON
1 2 3 4
OFF