Pioneer VSX-859RDS-G - Manual (Page 11)

11
En
PREP
ARA
TION
Operating range of remote
control unit
The area in which you can use the remote control to
operate the VSX-859RDS/VSX-839RDS is fairly large.
To use, point the remote control toward the remote
sensor on the front panel of this unit while within the
range shown right.
Remote control may not function properly if:
• There are obstacles between the remote control
and the
remote sensor.
• Direct sunlight or fluorescent light is shining onto
the remote sensor.
• The receiver located near a device emitting infrared
rays.
• Operated simultaneously with another remote
control which uses
infrared rays.
Before You Start
CAUTION!
Incorrect use of batteries may result in such hazards as
leakage and bursting. Observe the following precautions.
• Never use new and old batteries together.
• Insert the plus and minus sides of the batteries prop-
erly according to the marks in the battery case.
• Batteries with the same shape may have different
voltages. Do not use different batteries together.
• When disposing of used batteries, please comply with
governmental regulations or environmental public in-
stitution’s rules that apply in your country / area.
This illustration is the VSX-859RDS.
30
30
7m
Installing the Receiver
Ventilation
• When installing this unit, make sure to leave space
around the unit for ventilation to improve heat
radiation (at least 60 cm at the top, 10 cm at the
rear, and 30 cm at each side). If not enough space
is provided between the unit and walls or other
equipment, heat will build up inside, interfering with
performance or causing malfunctions.
• Do not place on a thick carpet, bed, sofa or fabric
having a thick pile. Do not cover with fabric or other
covering.
Anything that blocks ventilation will cause the
internal temperature to rise, which may lead to
breakdown or fire hazard.
Opening the Front Panel
To open the front panel push gently on the lower third
of the panel with your finger.
The PIONEER SR System:
Operating other PIONEER components
Connecting an optional control cord allows you to
operate other PIONEER components simply by
pointing the receiver's remote control at the remote
sensor on the front panel of the receiver. The receiver
then sends the remote control signals to the other
devices via the CONTROL OUT terminal.
OUT
IN
CONTROL
OUT
IN
CONTROL
PIONEER component
bearing the
Î mark.
Remote Control
To CONTROL IN
terminal of another
PIONEER component
bearing the
Î mark.
Receiver
memo
• You can also control PIONEER components (and those
made by other manufacturers) by pointing the receiver's
remote control directly at the respective component. This
type of operation does not require control cords. All you
have to do is recall the appropriate the stored settings
(see p. 68 – 70).
• If you use a remote control hooked up via the CONTROL
IN jack with a control cord, you won't be able to use this
unit's remote control.