Baracoda BaracodaPencil2 - Manual (Page 9)

BaracodaPencil2 – Programming Guide v1.7 - 9 -
Data Capture
for Workforce
in Motion
1.5/ Operating Mode
Real Time mode (standard mode): barcodes are transmitted in real time to the remote host device/terminal
(with optional acknowledgment beep from the host to the scanner). User can choose if the scanner, when not
connected, should read, memorize and later automatically upload the barcodes or shouldn’t read the barcodes
(no beam).
Batch mode: Barcodes are stored in the scanner even if the reader is connected to a device. In order to upload
the data the user will have to read the “discharge” barcode.
1.5.1/ Real time mode
Important reminder: if an ACK beep or bufferisation is needed, the scanner must be set in the “No Data Loss
mode” first.
Enable REAL TIME mode
Erases all codes in memory and forces the BaracodaPencil2 in Real time mode. No other setting is
changed.
Enable Real Time with « No Data Loss » mode
Enable Real Time without « No Data Loss » mode
Enable ACK beep
Forces the BaracodaPencil2 in Real Time mode (with data acknowledgement). Erases all codes in
memory. The BaracodaPencil2 should have been previously set in the “No data loss mode” ON (Scan
the “Enable Real Time with No Data Loss mode” barcode before).
Disable ACK beep
Forces the BaracodaPencil2 in Real Time mode (without data acknowledgement). Erases all codes in
memory. The BaracodaPencil2 should have been previously set in the “No data loss mode” ON.