Baracoda BaracodaPencil2 - Manual (Page 5)

BaracodaPencil2 – Programming Guide v1.7 - 5 -
Data Capture
for Workforce
in Motion
1/ General Configuration
1.1/ Reset all parameters:
The reading of the "Default settings” label turns all the parameters of the BaracodaPencil2 back to default
settings and switches it off.
Reset to factory defaults
1.2/ Erase all barcodes in memory
The BaracodaPencil2 has the ability to store barcodes in its internal memory (both in batch mode and in Real
Time with “No Data Loss Mode” ON). By reading the following barcode you will empty the internal memory of
the scanner.
Empty memory
1.3/ Baracoda advanced features
1.3.1/ Switch on delay
In order to switch on the BaracodaPencil2 in its standard mode, you should just press the trigger. You can set
up the scanner to be switched on only after keeping the trigger pressed for two seconds by reading the
appropriate barcode.
Switch on delay : 2 seconds Switch on delay : 0 second (*)
switch on delay : 2 secs
1.3.2/ Shutdown timers
There are two differents “shutdown timers”:
- when connected timer : delay between the last scanned barcode and the switch off when the
scanner is connected to a host
- Not connected timer : delay between the last scanned barcode and the switch off when the
scanner is not connected to any host
It is possible to set those timers to ‘infinite’. In that case, the scanner will stay all the time ON.
Set shutdown timers to infinity