Olympus VG-180 - Manual (Page 32)

32 EN
Turning on the camera with the Turning on the camera with the
q q button button dd [ [ q q Power On] Power On]
Submenu 2 Application
No
The camera is not turned on. To
turn on the camera, press the
n button.
Yes
Press and hold the q button
to turn the camera on in the
playback mode.
Saving the mode when the camera Saving the mode when the camera
is turned off
is turned off dd [Keep [Keep z z Settings] Settings]
Submenu 2 Application
Yes
The shooting mode is saved
when the camera is turned off and
is reactivated the next time the
camera is turned on.
On
The shooting mode is set to P
mode when the camera is turned
on.
Setting the operation sound Setting the operation sound
dd [Beep] [Beep]
Submenu 2 Application
On Enable operation beep.
Off Disable operation beep.
Adjusting the image processing Adjusting the image processing
function
function d d [Pixel Mapping] [Pixel Mapping]
● This function has already been adjusted at factory
shipping, and no adjustment is needed right
after purchase. Approximately once a year is
recommended.
● For best results, wait at least one minute after
taking or viewing pictures before performing pixel
mapping. If the camera is turned off during pixel
mapping, be sure to perform it again.
To adjust the image processing function To adjust the image processing function
Press the A button when [Start] (Submenu 2) is
displayed.
● The check and adjustment of the image
processing function starts.