Olympus E-3 - Manual (Page 54)

54
EN
4
Focusing and shooting functions
N Dynamic-single target AF mode
If the camera cannot focus on the subject using the
selected AF target, the camera focuses using the adjacent
AF target.
• When the button is released, the currently selected AF
target lights. When M or N is set, you can select the
AF target to be used at that point. For operation, refer to
Step 2 in “Selecting the AF target position” (
gP. 54)
in the next section.
• When M or N is set, you can turn the dial to select
the AF target.
• When M or N is set, you can select the AF target with p.
Selecting the AF target position
Select the AF target to use with Single target AF mode.
1
Press the P button and release your finger to enable selection of the AF target.
2
Use the main dial/sub dial or arrow pad to select
the AF target.
• Use the main dial to perform the same operation as
ac, and use the sub dial to perform the same
operation as bd.
• You can change the operation of the dials and arrow pad
for selecting the AF target. g“P SET UP” (P. 91)
• Press the i button to return the position of the AF target
to the center.
Direct button P + k
Super control panel i p: [AF AREA]P
+ k
Menu MENU[X][AF AREA]
Selected AF target
i button MENU button
P button
k
s0011_e_00_0_unified.book Page 54 Wednesday, September 12, 2007 4:46 PM