Olympus E-1 - Manual (Page 10)

10
Getting Started
En
Attaching a lens to the camera
4
Align the lens attachment mark (red) on
the camera with the alignment mark
(red) on the lens, then insert the lens
into the camera’s body. Rotate the lens
clockwise until you hear it click.
5 Remove the lens cap.
Note
● When you attach or remove the body cap and lens from the camera, keep the lens mount
on the camera pointed downward. This helps prevent dust and other foreign matter from
getting inside the camera.
● Do not point the lens attached to the camera toward the sun. This may cause the camera to
malfunction or even ignite due to the magnifying effect of sunlight focusing through the lens.
● Do not remove the body cap or attach the lens in dusty places.
● Be careful not to lose the body cap and lens cap.
● Attach the body cap to the camera to prevent dust from getting inside when no lens is
attached.
Select the lens that you want to shoot with.
Use a specified Four Thirds lens. When a non-specified lens is used, AF (auto focus)
and light metering will not function correctly. In some cases, other functions may not
work either.
Ⅵ Attaching the lens to the camera
Body cap
Rear cap
1 Make sure the power
switch is set to
OFF .
2 Remove the body
cap from the camera. 3 Remove the rear cap
from the lens.
Lens attachment mark (Red)
Alignment mark
(Red)
Lens cap
Ⅵ Removing the lens from the camera
1
Make sure the power switch is set to
OFF .
2 While pressing the lens release button,
remove the lens from the camera by
rotating it counterclockwise.
Lens release button
1 E-1 Ba-EN P1 03.7.8 5:55 PM Page 10