Olympus PT-037 - Manual (Page 22)

EN 22
En
Set the mode dial knob.
Make sure the camera is loaded properly.
Check the following points before sealing the Case.
• Is the digital camera loaded properly?
• Is the mode dial set to “SCN”?
• Is silica gel inserted all the way at the specified location?
• Is the O-ring attached properly to the opening on the Case?
• Is there any dirt or foreign matter on the O-rings or the O-ring contact
surfaces?
• Is the waterproof function maintenance performed?
After closing the rear lid of the Case,
push the Case’s mode dial knob on
its rear lid from the rear direction to
set the knob in position.
CAUTION:
• After setting the mode dial knob of the Case and before sealing it, turn the
mode dial to confirm that it can switch the mode dial of the digital camera.
• If the mode dial knob of the Case cannot switch the mode of the digital
camera, push the mode dial knob lightly while turning it.
Mode dial knob
PT037_EN.book Page 22 Monday, August 6, 2007 10:48 AM