Olympus PT-E05 - Manual (Page 13)

EN 12
En
Connecting the underwater optical fiber cable
Removing the TTL cable connector cap
To perform TTL flash shooting by connecting the separately available underwater flash or other products
to the Case using the underwater TTL cable (optional), remove the TTL cable connector cap as
described below.
„ How to attach the TTL cable connector cap to the case
Make sure there is no foreign matter attached to the O-rings inside the cap and on the TTL cable
connector. To secure the cap, gently turn it clockwise until it stops.
To connect the separately available UFL-2 underwater
flash to the Case using an underwater optical fiber cable
(optional), follow the procedures below.
• Put the underwater optical fiber cable plug all the way
into the optical fiber cable insertion slot.
1 Remove the TTL cable connector cap
from the Case.
2 Connect the underwater TTL cable
(optional) to the TTL connector on the
Case.
1 Turn counter
clockwise.
TTL cable connector
cap 2 Remove.
Underwater TTL
cable
Use this mark to
align the position.
3 Insert into the
connector.
4 Turn the threaded
section of the
connector clockwise
lightly until it stops.
Check O-rings
Cap Connector
2 Gently turn the cap
clockwise until it
stops.
1 Attach the cap to
the case.
PT-E05_EN.Book Page 12 Wednesday, June 4, 2008 12:34 PM