Alliance Laundry Systems SF250PV Tilt - Manual (Page 39)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
37 F232101
Programming Tutorial
The following procedure guides the programmer
through a complete cycle and allows hands-on
experience for programming cycles. The complete
cycle is listed in Table 3.
1. Locate the key-operated programming switch:
● On 135-pound models, the Program Mode
switch is located behind an access door
directly below the emergency stop button (top
right on the front panel of the washer-
extractor).
● On 250-pound models, the Program Mode
switch is located on the back side of the
computer access door (left side of front panel
of the washer-extractor) below the computer
board.
Insert the key and turn the switch to PROGRAM
position. The display will read “CYC00”.
2. Press the Add Cycle key. The display will read
“ACYC00”.
3. A two-digit number from 01 to 39 must be
entered. Cycle number 39 is recommended
because standard program versions use this short
cycle for performing a chemical supply setup.
4. Press key 3, then key 9, then the Enter key. The
display will read “CYC39”.
a. If the display alternately flashes “EXISTS”
and “EDIT?”, press the Clear/Stop key. The
display will return to “CYC39”.
b. Erase the existing cycle: Press the Erase Cycle
key. The display will show “ECYC39”. Press
key 3, then key 9, then the Enter key. The
display will read “WAIT” briefly and then
“CYC39”.
c. Press the Add Cycle key. The display will
read “ACYC39”. Press key 3, then key 9, then
the Enter key. The display will show “0139”.
5. Enter the desired function for step 1. A natural
choice might be hot fill to low level.
a. Press the Hot key and then the Low key. The
display will read “HL0139”.
b. Press the Enter key. The display will read
“M---S”.
c. Now enter the desired fill time. The
recommended number of minutes is four.
Press key 4. The display will read “4M-00S”.
6. Now press the Enter key. The display will read
“0239”, indicating that the computer is ready for
step 2 of cycle 39.
7. A natural choice for step 2 is the addition of a
supply.
a. To add supply No. 1, press the Supply key and
then key 1. The display will read “S10239”.
b. Press the Enter key and the display will read
“M---S”.
c. Now enter the desired time in minutes and
seconds for the supply valve to be turned on.
Thirty seconds is the recommended time.
Press key 0 for minutes, and the display will
read “0M-00S”.
Now press key 3 and then key 0. The display
will read “0M-30S”, indicating a supply time
of thirty seconds.
8. Now press the Enter key. The display will change
to read “0339”, indicating that the computer is
ready for step 3.