AEG Voxtel S110 combo - Manual (Page 19)

19
UK
tPress
OK
and / to select “AUTO ANS”.
tPress
OK
and / to turn on or off the auto answer feature.
tPress
OK
to confirm.
11.3.11 Set the direct memory keys
There are three direct memory keys M1, M2 and M3. You can store a number of up to 20
digits into each of these keys and dial them directly from idle mode, by pressing and holding the key for
more than 2 seconds.
tPress
and / to select “HS SET”.
tPress
OK
and / to select “MEM KEY”.
tPress
OK
and / to select the desired memory key from M1, M2 and M3.
tPress
OK
to enter a new number or edit the number stored already.
tPress
OK
to confirm
11.3.12 Set the mailbox number
You can store a number of up to 20 digits, which can be dialled out directly from idle mode by pressing
and holding the digit 1 key for more than 2 seconds. This may be used to store your network voice mail
number for easy access to that service.
tPress
and / to select “HS SET”.
tPress
OK
and / to select “MAILBOX”.
tPress
OK
and then enter a new number or edit the mailbox number.
tPress
OK
to confirm.
11.4 Base settings
11.4.1 Set the base ringer melody
tPress and / to select “BS SET”.
tPress
OK
and / to select “RINGER”.
tPress
OK
and / to select the desired ringer melody (a total of 5 melodies for your selection)
>The respective ringer melody will be played while browsing the melody list.
tPress
OK
to confirm.
11.4.2 Set the ringer volume
tPress and / to select “BS SET”.
tPress
OK
and / to select “RING VOL”.
tPress
OK
and / to select the desired ringer volume (a total of 6 ringer volume levels including “OFF”).
>The respective ringer volume will be played during your selection.
tPress
OK
to confirm.
11.4.3 De-register a handset
This operation should only be necessary if one of your handsets becomes faulty or lost and needs to be
replaced.
You will need to enter the 4-digit system PIN (Default PIN is 0000) in order to de-register a handset from
the base station. A de-registered handset will have the antenna flashing and “--UNREG--” on the display.
Note:
You cannot de-register the handset that you are currently using.
tPress and / to select “BS SET”.
tPress
OK
and / to select “DEL HS”.
tPress
OK
and the display shows “PIN?---”.
tEnter the 4-digit system “PIN”.
tPress
OK
and the first handset number is displayed.
tPress / to step through the list of registered handsets, and select the number of the handset you
want to de-register.
tPress
OK
to confirm, and the chosen handset will be de-registered.