AEG Voxtel S110 combo - Manual (Page 10)

10
tPress to dial to the selected redial number.
Note:
If there are no numbers in the redial list, the display shows “EMPTY ”.
7.10.2 Store a redial number into your contacts list
tIn idle mode, press to access the redial list.
tPress / to browse the redial list.
tPress
and / to select “STORE”.
tPress
OK
and then enter the name you want to use in your contacts list.
tPress
OK
and then modify the number, if necessary.
tPress
OK
to show “RING 1”.
tPress / to browse the ring tone list. The respective ring tone will be played when browsing the ring
tone list.
>The selected ring tone will only be played if you subscribe to caller display and the incoming number
matches the stored number.
tPress
OK
to confirm the selected ring tone and to save the entry.
7.10.3 Delete a redial number
tIn idle mode, press to access the redial list.
tPress / to browse the redial list.
tPress
and / to select “DELETE”.
tPress
OK
to confirm and the entry will be deleted.
7.10.4 Delete all redial list entries.
tIn idle mode, press to access the redial list.
tPress / to browse the redial list.
tPress and / to select “DEL ALL”.
tPress
OK
to display “CONFIRM?”.
tPress
OK
again to confirm.
>All entries will be deleted and the display will show “EMPTY”.
7.11 Find the handset
You can locate the handset by pressing on the base station. All the handsets registered to the base will
produce the paging tone and show “PAGING” on the screen. You can stop the paging by pressing /
/ on any handset or on the base again.
Note:
If there is an incoming call during paging, the phone will ring with the incoming call instead of paging.
7.12 Make an internal call
This feature is only applicable when there are at least two registered handsets. It allows you to make
internal calls, transfer external calls from one handset to another handset and make conference calls.
If the called handset is not answered within 60 seconds, the called handset will stop ringing and the calling
handset will return to standby mode.
Note:
If only one handset is registered to the base station, when
is pressed, it will display “FAILED ”.
7.12.1 Intercom another handset
tIn idle mode, press and all the other registered handset numbers will display, alone with a “9”.
tEnter the number of the handset that you want to call, or enter 9 to call all handsets.
tThe called handset rings. Press on the called handset to establish the internal call.
Note:
tIf only two handsets are registered to the base station, pressing
will call the other handset
immediately.