AEG Voxtel S110 combo User Manual

Page 12

7.14

Making a call from direct memory keys

tIn idle mode, press M1, M2 or M3 to dial the number stored in the direct memory keys via speakerphone.
Lift up the corded handset to switch the call to the handset mode.

Note:
If the selected direct memory key is empty, an error tone is emitted via speakerphone and the corded base
will return to idle mode.

7.15

Answering a call

tPick up the corded handset or press to answer the incoming call.

7.16

Ending a call

tDuring a call, put the corded handset on the base.
OR
tIf you are using the speakerphone, press to end the call.

7.17

Redial the last number

tIn idle mode, press

on the corded base. If there is a redial number, the number will dial out in

speakerphone mode.
Lift up the corded handset to switch the call to the handset mode.

7.18

Direct memory keys

There are 3 direct memory keys (M1 to M3) on the corded base for you to store frequent numbers, of up
to 24 digits each.
If more than 24 digits are entered, only the ﬁrst 24 digits are stored.

7.18.1

Saving a number in a direct memory key

tIn idle mode, press

tEnter the phone number.
tPress M1, M2 or M3 to store the number in that memory.
If there is already a number in your selected direct memory key, the new number will replace the previous
number.

Note:
The direct memory key cannot be cleared completely.
To remove a number, you can only overwrite it with a new number.

PAGING AND INTERCOM USE (FOR MULTI CORDLESS HANDSET SYSTEMS)

You can locate cordless handsets from the corded base or from other cordless handsets, and you can
make intercom calls between cordless handsets, or transfer calls between cordless handsets, or set up a
conference call between two cordless handsets and an external caller, provided you have more than one
cordless handset registered to your base.

Note:
You cannot make or receive intercom calls, transfers or conference calls with the corded base.

8.1

Find the handset

You can locate the handset by pressing the button on the front of the base station. All the handsets
registered to the base will produce the paging tone and show “PAGING“ on the display for 60 seconds.

You can stop the paging by pressing

/ /

on any handset or on the base again.

Note:
If there is an incoming call during paging, the phone will ring with the incoming call instead of paging.