AEG BP5304001B - Manual (Page 23)

To change length of selected procedure ( P1 or P2 ), press to set , then press or
to set length for the pyrolytic procedure.
You can use the End function to delay start of the cleaning process.
When the oven reaches pre-set temperature, the door locks. The symbol and the bars of
the heat indicator come up, until the door unlocks again.
During pyrolytic cleaning the lamp is off.
Cleaning reminder
To remind you that the pyrolytic cleaning is necessary the cleaning reminder symbol flashes
in the display PYR after every activating and deactivating the appliance for the next 10
seconds.
The cleaning reminder goes off the display:
• after end of the pyrolytic cleaning function;
• if you use or , when is flashing;
Shelf rails
You can remove the shelf rails to clean the side walls.
Removing the shelf rail
1. Pull the front of the shelf rail away from
the side wall.
2. Pull the shelf rail from the back of the side
wall to remove it.
To install the shelf rail follow the procedure in
reverse.
Valid with telescopic runners:
The retaining pins on the telescopic shelf run-
ners must point to the front!
Oven lamp
WARNING!
There is a risk of electrical shock.
Oven lamp and the lamp glass cover can be hot.
1
2
Care and cleaning 23