AEG L61270BI - Manual (Page 9)

F
The display shows the following information:
• Duration of the selected programme
– After setting a programme, the duration is displayed in hours and
minutes (for example ).
– After the programme has started, the remaining time is updated
every minute.
• Delay start
– When setting a delay start, the display shows the delay time (20
hours max.) for about 3 seconds (for example ), and then it
shows again the programme duration.
– The delay time value decreases by one unit every hour and then,
one hour before the end of the programme, the time decreases
every minute.
• Incorrect option setting
– In case of wrong setting the display shows the message Err and
the yellow light of the button 8 starts blinking.
• Alarm codes
– If an operating problems occur, the display can show some alarm
codes, for example (see chapter «Troubleshooting»).
• End of the programme
– At the end of the programme the display shows blinking zero ,
the symbol disappears and the door can be opened.
G TIME SAVING - option symbol.
H
DOOR - symbol
• This symbol indicates if the door can be opened:
– The symbol is on: the door cannot be opened. The appliance is
performing a washing programme.
– The symbol is off: the door can be opened. The washing pro-
gramme is finished.
I
Available options: PREWASH , STAIN , SENSITIVE , EXTRA
RINSE
5.2 Acoustic signals
The machine is provided with an acous-
tic device, which sounds in the following
cases:
• at the end of the cycle
• in the event of operating problems.
By pressing the 3 and 4 buttons simulta-
neously for some seconds, the acoustic
signal is deactivated (except for the
events of operating problems). By press-
ing these two buttons again, the acous-
tic signal is reactivated.
5.3 Child safety lock
This device permits you to leave the ap-
pliance unsupervised and not to worry
that children might be injured by or
cause damage to the appliance.
This function remains able also when the
washing machine is not working.
There are two different ways to set this
option:
• Before pressing button 8: it will be im-
possible to start the machine.
• after pressing button 8: it will be im-
possible to change any other pro-
gramme or option.
To enable or disable this option press si-
multaneously for about 6 seconds but-
ENGLISH
9