AEG L61270BI - Manual (Page 25)

Problem Possible cause/Solution
The applince does not
empty and/or does not
spin:
The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged.
• Clean the drain filter.
You have set an option or a programme that ends
with the water still in the tub or a that eliminates all
the spinning phases.
• Set the draining or the spinning programme.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
There is water on the
floor:
You have used too much detergent or unsuitable
detergent (creates too much foam).
• Reduce the detergent quantity or use another
one.
Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this as
the water runs down the hose; check to see if it is
damp.
• Check the water inlet hose connection.
The drain or the inlet hose is damaged.
• Replace it with a new one.
The cap on the emergency emptying hose has not
been replaced or the filter has not been properly
screwed in after cleaning action.
• Refit the cap on the emergency emptying hose or
screw the filter fully in.
Unsatisfactory washing
results:
You have used too little detergent or unsuitable de-
tergent.
• Increase the detergent quantity or use another
one.
Stubborn stains have not been treated prior to wash-
ing.
• Use commercial products to treat the stubborn
stains.
The correct temperature was not selected.
• Check if you have selected the correct tempera-
ture.
Excessive laundry load.
• Reduce the laundry load.
The door will not
open:
The programme is still running.
• Wait the end of washing cycle.
The door lock has not been released.
• Wait until the symbol
has gone off.
There is water in the drum.
• Set drain or spin programme to empty out the wa-
ter.
ENGLISH
25