AEG L61270BI User Manual

Page 33

• Hinges

To mount the hinges it is necessary to
drill two holes (dia. 35 mm, depth
12.5-14 mm depending on the depth
of door furniture) on the inner side of
the door. The distance between the
holes hobs fixing centres must be 416
mm.
The distance from upper edge of the
door to the centre of the hole de-
pends on the adjacent furniture's di-
mensions.
The hinges will be fixed to the door by
means of screws for wood 1 and 2
(Fig. 4) supplied with the appliance.

Fig. 4

• Mounting the door

Fix the hinges to the appliance by
means of the M5x15 screws . The hing-
es can be adjusted to compensate for
possible uneven thickness of the door.
To align the door perfectly it is neces-
sary to loosen the screw , adjust the
door and tighten the screw A again
(Fig. 5).

Do not remove the screw B (Fig.
5.

Fig. 5

• Counter-magnet

The appliance is prearranged for a
magnetic closure of the door. To ena-
ble a correct operation of this device,
it is necessary to screw the counter-
magnet A (steel disk + rubber ring) in-
to the inner side of the door.
Its position must correspond to the
magnet B on the appliance (Fig. 6).

Do not remove the screw C.

Fig. 6

ENGLISH