Xerox 4112-4127 Enterprise Printing System-3364 - Manual (Page 9)

Xerox 4112/4127 Notices
Xerox 4112/4127 Safety Guide 5
Notices
Radio frequency emissions
FCC in the USA
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the Federal Communications Commission (FCC) Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his/her own expense.
Changes or modifications to this equipment not specifically approved by the Xerox Corporation
may void the user’s authority to operate this equipment.
In Canada (ICES-003)
This Class “A” digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe “A” est conforme á la norme NMB-003 du Canada.
Regulatory information for RFID
This product generates 13.56 MHz using an Inductive Loop System as a Radio Frequency
Identification device (RFID). This RFID complies with the requirements specified in FCC Part
15, Industry Canada RSS-210, European Council Directive 99/5/EC, and all applicable local laws
and regulations.
Operation of this device is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Changes or modifications to this equipment not specifically approved by the Xerox Corporation
may void the user's authority to operate this equipment.
WARNING
Shielded cables must be used with this equipment to maintain compliance with FCC
regulations.