Xerox Stampante Xerox 8830 con AccXES Controller serial number N5T-16835 - Manual (Page 9)

XES FEATURE KEY INSTRUCTIONS
701P39462 12/02 Page 9
14. Verify that the Optional License(s) is/are present.
a. Print a Printer Configuration Test Print (Minimal) (Figure 3) or
on the WebPMT click PRINTER DEFAULTS, UTILITIES,
Configuration to open the Configuration screen (Figure 4)
b. Verify that the feature is enabled:
TEST PRINT (See Figure 3.)
•
Color license is located under the SCANNER
CONFIGURATION.
•
Check under the second column of the CONTROLLER
CONFIGURATION for OPTIONAL LICENSES. “Present”
should appear opposite the feature license that was
installed.
WebPMT (See Figure 4)
Select PRINTER DEFAULTS > UTILITIES > Configuration.
“Present” should appear opposite the feature license that was
installed.
15. Place the Test Print, along with a record of your Coupon ID, in
the service logbook located in the door panel of your printer.
16. Store the feature key diskette in a safe place, together with
your other drivers and software diskettes and CD’s.
17. Refer to the section entitled “Enabling a Feature Key (Optional
Feature),” at the end of this document, to enable the feature to
be used.
Redeem a Coupon for a Feature Key (Without Internet Access)
1. In the United States only, call Customer First at 1 877-XES-
DNCS. If you are outside the United States, please contact
your support representative for feature key instructions.
2. When you receive a diskette or e-mail containing the
appropriate file, follow the “Key Redemption With Internet
Access” procedure to enable the purchased feature.