Control panel – Konica Minolta bizhub C200 User Manual
Page 50
C200
x-49
Control panel
The control panel consists of the touch panel, which can be used to specify settings for the various functions,
and various keys, such as the [Start] key and the [Stop] key. The operations that can be performed with these
keys are described below.
In this manual, [ ] indicates keys on the control panel and buttons in the touch panel.
No.
Part name
Description
1
Touch panel
Displays various screens and messages.
Specify the various settings by directly touching the panel.
2
[Mode Check] key
Press to check the various settings.
3
[Utility/Counter] key
Press to display the Utility screen and the Meter Count screen.
4
[Fax/Scan] key
Press to enter Fax/Scan mode.
While the machine is in Fax/Scan mode, the indicator on the [Fax/Scan] key
lights up in green.
5
[Copy] key
Press to enter Copy mode. (As a default, the machine is in Copy mode.)
While the machine is in Copy mode, the indicator on the [Copy] key lights up
in green.
6
[Reset] key
Press to clear all settings (except programmed settings) entered in the control
panel and touch panel.
7
[Access] key
When account track settings have been applied, press this key to log on to a
registered account after entering the account name and password, and to log
off.
8
Sub power switch
Press to turn on/off machine operations. When turned off, the machine enters
a state where it conserves energy.
9
[Interrupt] key
Press to enter Interrupt mode. While the machine is in Interrupt mode, the in-
dicator on the [Interrupt] key lights up in green and the message "Now in Inter-
rupt mode." appears on the touch panel. To cancel Interrupt mode, press the
[Interrupt] key again.
10
[Stop] key
Press while copying to stop the operation. The copy job being performed is
deleted.
If the [Stop] key is pressed during scanning or dialing, a screen appears, re-
questing confirmation to delete a job. In the confirmation screen, select the job
to be deleted.
11
[Start] key
Press to start the copy, scan or fax operation. When this machine is ready to
begin the operation, the indicator on the [Start] key lights up in blue. If the in-
dicator on the [Start] key lights up in orange, the operation cannot begin.
Press to restart a stopped job.
12
Main power indicator
Lights up in green when the machine is turned on with the main power switch.
13
Keypad
Use to type in the number of copies to be produced.
Use to type in the zoom ratio.
Use to type in the various settings.