Konica Minolta bizhub C451 - Manual (Page 65)

2 Using copy functions
2-22 C451
Using copy f
unct
ions
Chapter 2
2.7 Selecting Finishing settings
Various settings can be selected for sorting and
finishing copies fed into the output tray.
The following Finishing settings are available.
Setting Description
Collate (By Set) Select this setting to separate each set of a
multi-page document.
Group Select this setting to separate the copies of
each page in a multi-page document.
Offset
*1
Select this setting to feed out and sort
printed copies in an alternating crisscross
pattern if the sorting conditions are met when
no finisher or separator is installed.
Select this setting to feed out and stack the
printed copies on top of each other with each
set shifted to separate it when a finisher is
installed.
Staple
*2*3
Select one of these settings to bind the
printed copies with staples. “Corner” or “2
Positions” can be selected.
Punch
*4*5
Select one of these settings to punch holes in
the copies for filing them.
Half-Fold
*6*7
Select this setting to fold copies in half before
feeding them out.
Center Staple &
Fold
*6
Select this setting to staple copies at two
places along the center, then fold the copies
in half before feeding them out.
Tri-Fold
*6
Select this setting to fold copies in three
before feeding them out.