Precautions for installation -2, Installation environment -2, Power source -2 – Konica Minolta PS7000C MKII User Manual
Page 18: 1 precautions for installation, 1 installation environment, 2 power source
PS7000C MKII Operator’s Manual
1 Precautions for Installation
1.1 Installation environment
Install the Scanner in a location, which meets the following requirements to ensure
safe operation and utmost performance.
◆
A place directly under the room lighting
A place where the illumination onto the book table is less than 300lx
A place where the illumination onto the book table is not uneven due to the light
from the lighting system or the outside through windows
An area free from direct sunlight
A place away from curtains or other objects that catch fire and burn easily
A place where there is no possibility of being splashed with water or other
liquid
A place not in the direct air stream from an air conditioner, heater, and/or
ventilator, ensuring fairly constant temperature
A well-ventilated place
A dry place
A dust-free location
An area not subject to undue vibration
A stable and level surface
1.2 Power source
The power source voltage requirements are as follows.
Use a power source with little voltage/frequency fluctuations.
Voltage fluctuation:
Up to 120 VAC ±10%, 230 VAC ±10%
Frequency fluctuation: Up to 50 Hz ±3 Hz
Up to 60 Hz ±3 Hz
If any other electrical equipment uses the same power outlet, make sure that the
capacity of the outlet is not exceeded.
The outlet should be located near the Scanner and easily accessible so that
power cord can be pulled out whenever necessary.
NEVER use a multiple adapter to connect other equipment or machines to the
outlet used by the Scanner.
If an extension cord is required, use one with a capacity higher than the power
consumption of the Scanner.
Make sure that no unusual, excessive force is applied to the power cord or
extension cord.
1-2