Konica Minolta bizhub PRESS C1060 - Manual (Page 7)

7
User authentication fails when registering users with two byte
characters on LDAP-enabled Fiery Color Servers
When User authentication is enabled, accounts of users that have two byte username
characters do not get authenticated with LDAP-enabled Fiery Color Servers. The user can still
print with the account.
If “305x458mm” is specified in Microsoft Word 2010, “12x18” is
listed instead and applied to the printer driver
If you specify “305x458” as the page size in Microsoft Word 2010 for the printer, the print
server properties window displays “12x18” instead. Set “Output Paper Size” instead of
“Document Size”.
Borders do not print when setting Papers per sheet to 6-up and
turning Print border on
When you print a Word document with the Papers per sheet setting set to 6-up, and Print
border turned on, sometimes border loss occurs with the print output. Send the job to print
in Command WorkStation to get the correct print out.
On Mac OS 10.8, install the driver by Find Printer By Name or Address,
job cannot be output
In the Fiery Printer Driver installation, if you find the printer by using the Find Printer By:
Name or IP Address feature, install the printer driver with any default queue selection, and
then try to print a test page, the document does not print. Reinstall the printer driver and use
the Find Printer By: Network Discovery feature to print the test page.
Cannot print a perfect bind document with the Windows and Mac OS
printer driver when using European languages
Send the print job to Command WorkStation, open Job Properties and send the document to
print. You can also send the print job directly to the Print queue in Command WorkStation to
print the document.
Fiery Color Server stops printing a document that has many pages and
N-up setting
Turn off the N-up setting for Pages per sheet and print the job to avoid the issue.
Fiery Impose Impose and Preview do not have the duplex setting “Top Binding”
In Impose and Preview, the Duplex setting “Top Binding” does not appear after importing a
job. After saving the impose settings and try to enable Top Binding in Job Properties, the
settings are cleared.